P0344 is an OBDII diagnostic code. It is a share code, which method that it has the same definition for the Dodge ram as the would any kind of other vehicle. If your Ram has this code, it method that the PCM (powertrain manage module) has detected the the camshaft place circuit is sending out an intermittent signal.

You are watching: P0344 camshaft position sensor circuit intermittent

Your camshaft position sensor sends out a signal ago to the PCM when the ignition is on. Its project is to measure the rotational position of the camshaft. This details is provided to manage engine performance and also timing, and also is checked against the crankshaft position sensor.

An intermittent signal way that the signal comes from this sensor is failing to reach the PCM at details points. The PCM will then expedition the check engine light and also you’ll get P0344.

P0344 is usually caused by an intermittent electric fault. That fault is usually led to by an worry coming from your Ram’s camshaft place sensor, or the sensor itself.

P0344 Symptoms: evade Ram

*

The symptoms of P0344 have the right to vary fairly a bit. In part cases, the only thing that the driver may notice is the examine engine light. In other cases, your Ram may not start at all.

Check Engine Light– This is often the just symptom of P0344. No Start– there is no data native the camshaft position sensor, it’s quite common to gain a no start from your Ram. The engine will crank, however that’s it. Tough to Start– If the camshaft position sensor is sending out an intermittent signal, it can be enough to acquire the engine started, however it might take much longer than normal. Rattling Sound– This shows that there might be an concern with the camshaft position sensor itself. Lost Power– there is no a strong signal indigenous the camshaft place sensor, the is usual for engine strength to suffer.

P0344 Causes: dodge Ram

Here are some of the most common reasons of P0344:

Wiring Issues: Camshaft place Sensor

One the the many common reasons of P0344 is wiring related. If there is an open up or short in between the wiring harness and PCM, the signal will be intermittent. Make sure that the wiring harness is sit well right into the camshaft place sensor and not damaged in any way.

An investigate of the wiring exploit is a good place come start trying to find the cause of P0344. You’ll desire to look for cracked, burnt, or exposed wiring, and also inspect the harness plugs.

Bad Camshaft place Sensor

The camshaft place sensor itself can go negative over time. It will no longer have the ability to send a signal to the PCM and your ram will acquire the intermittent P0344 code.

Battery

P0344 is understand to be triggered by a battery that has actually low/no charge. If you’ve recently tried to start your Ram with a battery favor this, that might be what threw the code. If there room no various other symptoms various other than P0344, and also the battery to be low/dead, it’s highly likely that’s what caused it.

See more: Let'S Fly! Discussion How To Turn Up Your Gamma In Minecraft 1

Starter

A bad starter or wiring issue in the starter system circuit can cause P0344. It’s not almost as common as the camshaft place sensor or it’s wiring to have actually gone bad.

Conclusion: P0344 evade Ram

This is among the more commonly misdiagnosed codes. It is in thorough in her inspection that the wiring harness. That’s commonly the cause. Also, the signal might be intermittent now, but it could not it is in long prior to it it s okay worse and also your lamb won’t start at all. Try and acquire it repaired as shortly as possible. An excellent luck!