Then eliminate the 4 7 mm headed screws that host the liner to the dash; 2 on every side.

You are watching: How to replace blower motor 1995 chevy truck

*

The silver crate is the PCM and underneath the is the foam and also rubber cover that has to be removed. Over there will normally be a same amount that dust on whatever in this corner of the dash. This one additionally has a an excellent bit that hair native a dog. I supplied my shop vac to remove the worst the the hair and also dust.

*

With the clips gotten rid of the PCM deserve to be positioned to do it simpler to eliminate the exploit connectors. Although the PCM is reasonably rugged the is ideal to treat the as delicate as possible. Make certain you depress the latches and pull the exploit connectors right out. As soon as the harnesses space disconnected, the PCM can be gotten rid of from the glove box opening.

*

The 2 on the front leaf only need to be loosened to remove the bracket.

*

At this allude the wires can be disconnected indigenous the blower motor. The floor wire has a latch that has to be depressed. You can additionally remove the 2 front screws that organized the PCM bracket in place. It renders it slightly less complicated to eliminate the cover.

*

Now the top edge can be lifted up and also off that the hooks.

*

Now eliminate the screws form the sill plate (sorry no picture) and also then remove the appropriate kick panel cover.

*

Use a pry bar to complimentary the bracket form the pivot pin.

*

Go approximately the outer edge of the blower motor and remove the mounting screws. Execute not remove the grounding tab screw at this point. Girlfriend will additionally need to remove the small rubber hose that connects between the next of the blower motor and the tube on the blower case. This water tap is really important to the life of the blower motor. Carry out Not shed it and DO remember to install it top top the brand-new motor. It supplies some the the waiting from the blower case and also directs it into the blower windings to keep the blower engine cool.

*

Be sure to clean the blower case and also the evaporator fins of all debris before reassembling. I supplied my shop vac v a tiny hose attachment.

*

Remove the repaint from the area whereby the ground connection tab will be placed on the brand-new motor.

*

Note the vent hole on the old blower motor.

*

Reassemble the blower motor right into the dash and install all eliminated parts. The top two screws that room in recesses in the PCM mounting key cane be difficult to start. Ns sue a small trim adhesive on the screw head to host the screw into a socket. This provides it easier to install. Also remember to install the 2 screws in the front edge of the bracket, earlier onto the blower case, prior to the parentheses is installed. That way all you need to do is tighten castle up. Much easier than make the efforts to download them through everything ago in place.

See more: 2001 Nissan Maxima Crankshaft Position Sensor Location, Crankshaft Sensor Location

*

This one is a major power supply because that the ignition switch, if ns remember correctly.

*

Make sure you take the time to properly install all of the eliminated parts. Now the blower engine will occupational with minimal noise.