This overview shows how to change the major VSS sensor top top Nissan equipped v the 3.5L V6 engine and CVT transmission. Note that her Nissan may have actually a secondary VSS sensor that is resulting in the problem.

The transmission rate sensor on Nissan CVT automatically transmission may fail, bring about shiftingtransmission may fail, leading to shifting problems. 


It can reason hard shifting, check engine light, or a bang when you move the shifter indigenous Park to journey or Reengine light, or a bang once you relocate the shifter indigenous Park to journey or turning back gears.

You are watching: 2006 nissan murano speed sensor location

This infection is mounted on lot of cars, including Nissan Altima, Cube, Juke, Maxima, Murano, NV Cargo, Pathfinder, and Quest.

Symptoms

Symptoms of negative transmission speed sensor

Harsh shiftingPossibly related Fault Codes

What you need

10mm socket, extension, and ratchet.4" Extension

Procedure

There space two methods to replace the speed sensor on Nissan CVT transmission.

This very first requires removing the battery and also the starter, which will take a lot of time.

The 2nd is to accessibility the rate sensor from the bottom the the engine. The sensor is on the side of the transmission housing facing the front. That is ~ above the same side together the starter. 

Remove the plastic splash shield indigenous the bottom that the engine.Disconnect the electrical connector. Use a flat screwdriver come pry the plug away from the sensor.
*
Remove the 10mm bolt. Gain it loosened using your 10mm socket and ratchet. Next, eliminate the bolt by hand.
*
Remove the old speed sensor indigenous the infection housing. There may be a small amount of oil leaking indigenous the sensor hole.
*
Tighten the 10mm bolt. Connect the electric connector. 
*
Lower the vehicle and follow the ideal procedure to check the automatic transmission transmission liquid level.

If the inspect engine light is on, plug one OBD2 scanner into the diagnostic port under the dashboard (driver"s side) to read and clear any type of stored faengine light is on, plug one OBD2 scanner right into the diagnostic port under the dashboard (driver"s side) to read and clear any stored fault codes. 


Notes

The sensor is right below the starter. If you room accessing the sensor from underneath the vehicle, making use of a 1/4" ratchet and 4" extension is far better to gain to the 10 mm bolt.

Input speed Sensor Location

On Nissan vehicles equipped v the CVT transmission, the input rate sensor is situated on the side of the transmission housing.

See more: How Do You Find All The Factors Of 147 In Pairs (Factor Pairs For 147)

How come diagnose Nissan transmission rate sensor

A mechanic will affix an OBD-II infection scanner that have the right to read Nissan codes. 

Locate the OBD2 harbor under the dashboard.Turn the ignition to position II. Every dash lights will rotate on.Allow the scanner to power on.Select check out codes.Verify the fault codes room pointing to a faulty transmission rate sensor.