Hello,The crankshaft sensor is near the front of the engine near the oil filter here is a guide to walk you through changing it with diagrams and instructions on how to do the job on your car below.https://www.moment-g.com/articles/crankshaft-angle-sensor-replacementCheck out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.
Where is the crankshaft position sensor, there are all kinds of info where camshaft sensor is but none of 3.5 crankshaft sensor
We have no pic but it's at left hand side of oil pan. Probably hard to see and to get to with trans there.
Yes, you are correct, next to oil pan. I bought two and I am supposing that there is only one? The one I installed was straight, (1st pic) and the other I bought has an angle which I do not know where it goes, if I even need two but, I was told it takes or has two?
Can you tell me where the crankshaft position sensor is located? My mother-in-law got an error code saying it was going bad and the shop wanted $500 to replace it. I"m sure I can handle it but I need to know where it is. Thank you.
There are two of these in a 2002 Max. They are located on the right side (looking from the front of the car). Google for Max 2002 CPS location and you"ll be able to find a picture of it"s location. They cost less than $100 each from a dealer, and installation is very simple: disconnect the plug cable, remove ONE retaining screw (10 mm, I think), and pull out the old one and put in the new one. Plug the cable back and you"re done. Its no more than a 10 minute job per CPS.BTW, there is a green latch on the plug that you push down and pull the plug up to release the latch.
What small world that happen to me. I had to change cam shaft sensor and something craft shaft sensorcam cost like 70 and craft cost 50my mechanic put it for free cause he own my dad a favor but I saw him do it. The cam shaft is easier it right next to the motor craft shaft they had to lift car up. I think in a normal mechanic not a dealership it should cost like 60 bucks with parts like 120btw does your car turn of while driving? Mines doing this but cant find solution
Before I had my CPS replaced, yes, the engine would occasionally just turned off and I had to cruise to the side of the street without power. Once there I can restart the negine and it took a couple of tries before it would fire back up and able to drive again. If you only replace one of the CPS, perhaps your other one is also going bad. I"d check to see if you have another CEL code stored.
I Have A 2001 Nissan Maxima My Obd2 Scanner Was Throwing A P1335 Code. The Car Started Fine Ran Good But It Had A 0420 Code For Years Now....
You are watching: 2001 nissan maxima crankshaft position sensor location
I Have A 2k3 6 Speed, I Just Replaced The Engine, At First I Kept Getting The P0335 Code, But The Car Would Take A Long Time To Start But...
About Gas Coming Out Exhast System Crunk This Morning An Shut Off Found Out The Number One Cyl Injector Was Dumping Gas Replaced Inj An...
See more: “ Life Is Not Measured By The Number Of Breaths We, Maya Angelou
I Have A 2002 Nissan Maxima Gle. The Car Is Stalling While Driving And With The Ac On It Runs Worst. A Friend Put His Code Computer And...